Transmission Control Lever Knob Replacement
Removal Procedure
- Remove mat (1).
- Clip instrument panel lower centre compartment
liner (2) out of front floor console using a suitable plastic
tool (3).
- Remove transmission control lever boot (1) from
front floor console, gently pulling boot frame on front side
upwards.
- Slide transmission control lever boot upwards.
- Press 2 catches (arrows).
- Slide blue transmission control lever retainer
ring (1) upwards.
- Pull trigger (2) upwards.
- Remove transmission control lever knob
- Press pull latch (1) in direction of arrows.
- Remove reverse gear block (2) from transmission
control lever knob.
Installation Procedure
- Install reverse gear block (2) to transmission
control lever knob.
- Let the hook (1) engage
audibly (arrow).
- Install transmission control lever knob.
- Push trigger (2) upwards.
- Press the transmission control lever knob during
installation completely down.
- Slide blue transmission control lever retainer
ring (1) downwards.
- Clip instrument panel lower centre compartment
liner (2) to the front floor console.
- Install mat (1).
- Clip transmission control lever boot (1) into
front floor console.
|