Transmission Housing, Replace (F 13)
Remove, Disconnect Remove transmission - see operation "Manual Transmission and Differential, Remove and Install". Attach KM-444-C to transmission. Attach transmission with KM-444-C (1) to KM-113-2 (2). Remove shift mechanism cover (5) with shift guide (6) - see operation "Cover for Shift Mechanism, Remove and Install and / or Seal". Remove reversing lamps switch (4). Remove end shield cover (3) - see operation "End Shield Cover, Remove and Install". Remove end shield - see operation "End Shield Gasket, Replace". |
|
Remove, Disconnect Remove differential - see operation "Differential, Remove and Install (F 13)". Remove bearing for main shaft (6) and drive shaft (5) - see operation "Bearings for Main Shaft and Drive Shaft, Remove and Install (F 13)". Remove clutch thrust bearing (4), clutch thrust bearing guide (1) and release lever (2) - see operation "Clutch Disc, Thrust Plate, Clutch Thrust Bearing and / or Release Lever, Remove and Install". Remove bearing bushings (3) for clutch release lever - see operation "Bearing Bushings for Clutch Release Lever, Remove and Install". Remove transmission casing from KM-444-C. |
|
Install, Connect Attach new transmission casing to KM-444-C. Install bearing bushings (3) for clutch release lever - see operation "Bearing Bushings for Clutch Release Lever, Remove and Install". Install clutch thrust bearing (4), clutch thrust bearing guide (1) and release lever (2) - see operation "Clutch Disc, Thrust Plate, Clutch Thrust Bearing and / or Release Lever, Remove and Install". Install bearing for main shaft (6) and drive shaft (5) - see operation "Bearings for Main Shaft and Drive Shaft, Remove and Install (F 13)". |
|
Install, Connect Install differential - see operation "Differential, Remove and Install (F 13)". Install end shield (1) - see operation "End Shield Gasket, Replace". Install end shield cover (2) - see operation "End Shield Cover, Remove and Install". Install reversing lamps switch (4) with new seal ring - tightening torque 20 Nm / 15 lbf. ft. Install shift mechanism cover (3) - see operation "Cover for Shift Mechanism, Remove and Install and / or Seal". Remove transmission with KM-444-C from KM-113-2. Remove KM-444-C from transmission. Install transmission - see operation "Transmission, Remove and Install". |
|
|