Load Compartment Grille, Remove and Install (Model
F 08 & W5L).
Remove
1. |
Remove C-pillar inner panelling
|
2. |
Remove load compartment floor covering
|
|
3. |
Remove load compartment grille
• |
Release 2x bolt on rear quarter panel (1)
|
• |
Unscrew and remove 2x bolt, load compartment grille, on load
compartment partition (2)
|
• |
Unscrew and remove 2x bolt, partition bracket on inner rear
quarter panel (3)
|
• |
Unscrew and remove 2x bolts on load compartment partition
(floor) (4)
|
|
4. |
Pull load compartment grille towards the rear with load
compartment partition
• |
Unscrew and remove bolts on inner rear quarter panel (1) and
take out load compartment cover.
|
|
|
|
5. |
In the following countries, the load compartment grille is
secured with shear bolts:
Austria
|
Netherlands
|
Belgium
|
Hungary
|
|
6. |
For the removal of the load compartment grille, all the shear
bolts (arrows) must be released by hitting with chisel (1).
|
7. |
The following shear bolts are supplied by the Aftersales
division:
Part No. 90 468 473
|
Catalogue No. 912983
|
Part No. 90 468 472
|
Catalogue No. 912982
|
Note: The shear bolt 90
468 473 is for attaching partition bracket to rear quarter
panel
|
|
Install
|
8. |
Insert load compartment grille in load compartment partition
and slide into position ready to be screwed in
Note: Lay felt underlay
underneath between partition bracket and the attachment point on
the inner rear quarter panel.
• |
Tighten 2x bolt (1) on the inside of the rear quarter panel
20 Nm
|
• |
Tighten 2x bolts (2) on the floor for load compartment
partition 20 Nm
|
• |
Tighten 2x bolt (3) of the bracket for the load compartment
partition on the inside of the rear quarter panel 20 Nm
|
• |
Tighten 2x bolts (4) for load compartment grille on load
compartment partition 20 Nm
|
|
|
9. |
Install load compartment floor covering
|
10. |
Fit C-pillar inner panelling
|
|