|
Control Component for ECC, Remove and Install
 Remove
| 2. |
Remove radio installation
|
|
| 3. |
Detach ECC operating component from instrument panel
|
| 4. |
Remove ECC control component
Note: Carefully unlatch
ECC control component at the bottom with plastic wedge (arrows) and
pull out forwards.
|
|
|
| 5. |
Disconnect wiring harness plugs (1) and (2) from ECC control
component and draw out ECC control component
| • |
Unlatch 2x wiring harness plug (3) and remove in the direction
of the arrow
|
|
|
Install
| 6. |
Connect and latch wiring harness plug for ECC control
component.
|
| 7. |
Install ECC control component in instrument panel
|
| 8. |
Fit radio installation
|
| 10. |
Perform function check
Note: Calibration is
performed automatically by the system.
|
|
