|
Brake Line from Brake Master Cylinder to Hydraulic
Modulator, Remove and Install
Vehicles with Left Hand Drive
 Remove
| 1. |
Pull seal (1) away from plenum chamber as far as necessary
| • |
Lift up covering flap (2) for brake master cylinder
|
|
| 2. |
Detach closure cap (3) from brake fluid reservoir
|
| 3. |
Disconnect wiring harness plug (4) of sensor for brake fluid
monitoring device
| • |
Detach guide (6) for brake line on plenum chamber
|
|
Warning: Remove escaped brake fluid
immediately.
|
| 4. |
Detach brake lines at brake master cylinder (5) and hydraulic
modulator (7) and remove
Note: Observe
installation position.
|
|
|
Install
| 5. |
Lay brake lines and attach to hydraulic modulator (1) and brake
master cylinder (4) - tightening torque 16
Nm
Note: Observe
installation position.
|
| 6. |
Connect wiring harness plug (3) for sensor of brake fluid
monitoring device
| • |
Connect guide (5) for brake line to plenum chamber
|
|
| 7. |
Remove MKM-558-10 from brake fluid
reservoir
|
| 8. |
Bleed brake system and check for leaks 
|
| 9. |
Install closure cap (2) on brake fluid reservoir
|
| 10. |
Close covering flap (6) for brake master cylinder
| • |
Place seal (7) on plenum chamber
|
|
|
|
|
