|
Brake Calliper – Front Wheel Brake, Remove
and Install
 Remove
| 1. |
Detach seal for plenum chamber as far as necessary.
|
| 2. |
Raise covering flap for brake master cylinder
|
| 3. |
Detach closure cap and seal brake fluid reservoir with MKM-558-10 .
|
| 4. |
Remove brake linings of front wheel brake 
|
| 5. |
Detach banjo bolt (1) from brake calliper
| • |
Collect brake fluid and seal apertures
|
|
| 6. |
Detach fastening bolt (2) for upper brake calliper guide pin
from retaining frame and remove brake calliper.
|
|
|
Install
| 7. |
Attach brake calliper to retaining frame with new fastening
bolt (4) for upper brake calliper guide pin - tightening torque
27.5 Nm
|
| 8. |
Install banjo bolt with new seal rings - tightening torque
40 Nm
Note: Ensure that the
brake hose is not twisted.
|
| 9. |
Install brake linings of front wheel brake
|
| 10. |
Bleed brake system and check for leaks
|
| 11. |
Press brake pedal repeatedly
|
| 12. |
Correct brake fluid level so that it reaches the "MAX"
mark.
|
|
