|
Brake Pedal with Pedal Support, Remove and Install
(Vehicles with RHD)
 Remove
| 2. |
Remove fastening bolt (1) for brake pedal bracket support from
bulkhead
|
| 3. |
Release brake light switch wiring harness plug (2) and
disconnect
| • |
Release wiring harness plug for pedal sensor (5) and
disconnect
|
| • |
Detach brake pedal return spring (4) from brake pedal
|
|
| 4. |
Detach retaining clamp (6) for piston rod fastening pin at
brake pedal and remove fastening pin (3).
|
| 5. |
Detach fastening nuts (arrows) for brake pedal at bulkhead and
remove brake pedal with pedal support and bracket.
Note: When replacing
the brake pedal with pedal support, the brake light switch and the
pedal support bracket for the brake pedal must be transferred.
|
|
|
Install
| 6. |
Insert brake pedal with pedal mounting and support for pedal
mounting into fastening bolts on bulkhead and attach with new
fastening nuts (arrows)
Note: Ensure that the
piston rod of the brake servo is seated in the brake pedal.
Tightening torque for pedal mounting to bulkhead 20 Nm .
|
| 7. |
Secure fastening bolt (2) for brake pedal to piston rod for
brake servo and secure with retaining clip (5)
| • |
Attach brake pedal return spring (3) to brake pedal
|
|
| 8. |
Fit fastening bolt (6) for brake pedal bracket support to
bulkhead - tightening torque 20 Nm
|
| 9. |
Connect wiring harness plug (1) to brake light switch
| • |
Connect wiring harness plug (4) to pedal sensor
|
|
|
|
|
