Crankshaft Impulse Sensor, Corsa/Mervia Z17DT
Objective:
Checking operation of the impulse sensor on the crankshaft.
Measurement:
Plot of voltage at the signal output for the impulse sensor on
the crankshaft.
Preparation:
Switch off the engine and ignition.
Connections:
INPUT A
|
COM/TRIGGER
|
INPUT B
|
Connect the red measurement lead to pin 3 of the plug connector
for the Crankshaft sensor. Connect the black ground lead to pin
1.
|
|
|
Procedure Tech 31:
1. |
Download the Reference curve. |
2. |
Start the engine and allow it to idle. |
Reference Curve:
|
|
Procedure Tech 32:
1. |
Download Setup file (the Tech 32 uses only Setup
files, no reference curves). |
2. |
Start the engine and allow it to idle. |
Setup File:
Reference Curve:
|
|
|