Throttle Valve Potentiometer (Double Signal),
Multec/Trionic (MY 2001, MY 2002 and MY 2003), Simtec (MY 2001 and
MY 2002)
Objective:
Checking the electrical and mechanical functions of the throttle
valve potentiometer.
Measurement:
Voltage plot of both signal outputs of the throttle valve
potentiometer.
Preparation:
Switch off the engine and ignition.
Connections:
INPUT A
|
COM/TRIGGER
|
INPUT B
|
Connect the red measurement lead to pin D (Z16XEP: C) of the
connection plug on the throttle valve potentiometer. Connect the
black ground lead to ground.
|
|
Connect the grey measurement lead to pin A (Z16XEP: G) of the
connection plug on the throttle valve potentiometer.
|
Procedure Tech 31:
1. |
Download the Reference curve. |
2. |
Start the engine. |
3. |
Depress the accelerator pedal quickly down to the
limit stop and then release it again. |
Reference Curve:
|
|
Procedure Tech 32:
1. |
Download Setup file (the Tech 32 uses only Setup
files, no reference curves). |
2. |
Start the engine and allow it to idle. |
3. |
Depress the accelerator pedal quickly down to the
limit stop and then release it again. |
Setup File:
Reference Curve:
|
|
|