Replace engine damping block (right side) (Z 10
XE, Z 10 XEP, without air conditioning, LHD)
Note: KM-6394 must be used as of model year 04 instead of
KM-6169-1 .
Remove
2. |
Remove air cleaner housing (1)
• |
Disconnect 2 wiring harness plugs
– |
Hot film mass air flow sensor (3), tank vent valve (2)
|
|
• |
Remove suction pipe (4)
– |
Detach engine vent hose (5)
|
|
• |
On Z 10 XEP: Remove air intake hose
|
|
|
|
4. |
Remove ribbed V-belt cover
Note: In "ECO" model
variant remove lower engine compartment cover, see operation
"J481500 Removing and installing lower engine compartment cover
(ECO)" in group "A"
|
|
|
5. |
Attach KM-6169-2 to transmission
|
|
|
6. |
Attach KM-6169 (1)
• |
Place left of KM-6169 onto front axle body (arrows, illus.
I)
– |
Guide pin must be seated in bore in front axle body
|
|
• |
Attach both right holders on the front axle body (arrows,
Illus. II).
– |
Guide pin must be seated in bore in front axle body (arrow,
Fig. III)
|
|
|
|
|
|
7. |
Attach connection to KM-6169
• |
Adjust bracket (2) for support
|
|
8. |
Adjust supports
• |
Transmission side
– |
Turn spindles until mounts (3) are positioned at guide journals
free of play
|
|
• |
Engine timing side
– |
Insert journal of the support in the bore of the cylinder block
without play (arrow)
|
|
|
|
9. |
Loosen right engine bracket
|
|
|
11. |
Remove right engine bracket
• |
Loosen engine damping block
|
• |
Unscrew 2x bolt (arrows)
|
|
12. |
Loosen coolant pump ribbed V-belt pulley
|
|
|
Install
13. |
Install right engine damping block
• |
Tighten 2 bolts (2) 40 Nm
|
• |
Tighten 2x bolts (1) 60 Nm
|
|
|
|
18. |
Install ribbed V-belt cover
Note: In "ECO" model
variant install lower engine compartment cover, see operation
"J481500 Removing and installing lower engine compartment cover
(ECO)" in group "A"
|
20. |
Install air cleaner housing
• |
On Z 10 XEP: Fit air intake hose
|
• |
Attach engine vent hose
|
• |
Clip in tank vent valve
|
• |
Connect 2 wiring harness plugs
|
|
|