Check compression (Z 10 XE, Z 10 XEP, with air
conditioning system, LHD)
Note: Engine warmed
up (oil temperature at least 80°C).
Remove
2. |
Remove ignition module
• |
Remove ignition module cover
|
• |
Disconnect wiring harness plug
|
• |
Extract using KM-6009 (1)
Note: Do not tilt
|
|
|
|
3. |
Remove spark plugs
• |
Unscrew 3x with KM-194-E
|
|
4. |
Remove fuel pump relay
• |
Pull out fuel pump relay (arrow)
|
|
|
|
5. |
Check compression
Note: Second person
required
• |
Actuate accelerator pedal
– |
Retain full load position
|
|
• |
Start engine (approx. 4 seconds)
Note: Engine speed at
least 300 rpm
|
• |
Compare compression values
– |
Maximum permissible pressure difference: 100 kPa (1 bar).
|
|
|
|
|
Install
6. |
Install fuel pump relay
|
7. |
Install spark plugs
• |
Tighten 3x with KM-194-E 25 Nm
|
|
8. |
Install ignition module
• |
Connect wiring harness plug
|
• |
Fit ignition module cover
|
|
|