|
Check timing (Z 14 XE with air conditioning LHD, Z
16 YNG)
|
1. Open bonnet
2. Remove air cleaner housing (1)
- Disconnect wiring harness plug
- Intake air temperature sensor (4), tank vent valve (2)
- Unclip tank vent valve
- Remove air intake pipe
- Remove air intake hose
- Remove bolt (3)
|
|
|
3. Remove upper part of toothed belt
cover
- Remove 3 bolts (arrows)
- Unclip from rear toothed belt cover
4. Raise vehicle
|
|
|
5. Remove ribbed V-belt cover
- Remove 3 bolts (1)
- Remove clip (arrow).
6. Lower vehicle
|
|
|
7. Timing, Check
- Set crankshaft to mark.
- Turn crankshaft evenly
- Note: Marks on crankshaft ribbed V-belt pulley and front
toothed belt cover (2) must align
- Fix camshaft sprockets in position.
- Note: Marks (1) must be opposite one another and aligned with
the top edge of the cylinder head
- Insert KM-852
- Note: If KM-852 cannot be inserted, a basic adjustment of the
timing must be performed
|
|
8. Remove KM-852
9. Install upper part of toothed belt cover
- Clip to rear of toothed belt cover
- Tighten bolts (4 Nm / 3 lbf. ft)
10. Install air cleaner housing
- Tighten bolt
- Install air intake hose.
- Install air intake pipe
- Clip in tank vent valve
- Connect wiring harness plug.
11. Raise vehicle
12. Install ribbed V-belt cover
- Screw in bolts
- Install clip
13. Lower vehicle
14. Close bonnet
|
