Replace automatic transmission solenoid valve
wiring harness (AF13-II)
Remove
1. |
Disconnect wiring harness plug
• |
From transmission input speed sensor
|
• |
From transmission output speed sensor
|
|
2. |
Remove selector lever position switch
|
3. |
Remove bolt (2) for transmission wiring harness retaining
plate
• |
Release and disconnect transmission wiring harness plug (1)
|
|
4. |
Remove valve body cover
|
|
|
5. |
Disconnect wiring harness plug from solenoid valves:
- Neutral shifting (1)
- Pressure regulator (2)
- 2-3 gearshift valve (3)
- 1-2 / 3-4 gearshift valve (4)
- Converter clutch (5)
- Unclip temperature sensor (6)
|
7. |
Remove wiring harness upwards out of transmission housing
|
|
|
Install
8. |
Insert transmission wiring harness into transmission housing
with new O-ring (1)
|
10. |
Connect wiring harness plugs of solenoid valves and pressure
regulator
Note: Ensure that
cables are laid correctly.
- Neutral shifting (2)
- Pressure regulator (3)
- 2-3 gearshift valve (4)
- 1-2 / 3-4 gearshift valve (5)
- Converter clutch (6)
- Clip in temperature sensor (7)
|
11. |
Install valve body cover
|
|
|
12. |
Attach retaining plate for wiring harness (2) to
transmission
• |
Tighten retaining plate 8 Nm
|
|
13. |
Connect and lock wiring harness plug (1) for transmission
wiring harness
|
14. |
Connect wiring harness plugs for transmission input speed
sensor and transmission output speed sensor
|
15. |
Install and adjust selector lever position switch
|
16. |
Adjust selector lever position switch
|
17. |
Check and correct transmission fluid level
|
|
|
|