Vauxhall Workshop Service and Repair Manuals

Replace bearing in transmission housing (F13/F13 MTA)

Note:   Transmission remains installed.

  Remove

1.   Remove gearshift cover (1) •   F13/F17/F17 new/F17+ •   MTA 2.   Remove reversing lamp switch (2) •   F13 only 3.   Remove end shield cover (3) 4.   Remove end shield (4) from transmission

6.   Pull needle bearing (3) for bearing of drive shaft out of transmission with KM-556-A (1) and MKM-599 (2) 7.   Pull roller bearing (4) for bearing of main shaft out of transmission with KM-556-A (6) and KM-556-2 (5)

  Install

Important:   Do not drive in roller bearing flush, otherwise the bearing will be damaged. 8.   Install new roller bearing (3) for bearing of main shaft in transmission with KM-454-3 (5) in combination with KM-454-4 (4) •   Drive in roller bearing as far as it will go 9.   Install new needle bearing (2) for bearing of drive shaft with KM-454-2 (6) in combination with KM-454-4 (1) Note:   Needle bearing side with writing points to transmission. •   Drive in needle bearing flush

11.   Install end shield (1) in transmission 12.   Install end shield cover (2) 13.   Install reversing lamp switch (4) with new seal ring •   F13 only •   Tighten switch 20 Nm 14.   Install gearshift cover (3) •   F13/F17/F17 new/F17+ •   MTA 15.   Check transmission fluid level •   F13/F17/F17 new/F17+ •   F13 MTA/F17+ MTA