Replace airbag unit, driver's side
Remove
2. |
Observe waiting time for airbag deactivation, 1 min.
|
|
3. |
Remove airbag, driver's side
• |
Steering wheel in straightahead position
|
• |
Punch through perforated service opening (1) on both sides of
the steering wheel and and using a screwdriver (2), press both
retaining wires (arrows) in the direction of the steering column
and remove airbag module (3).
Note: On release,
ensure that the screwdriver (2) does not rest on the airbag plastic
frame (4).
Screwdriver must rest on the retaining wire (arrows). Ensure that
the retaining wire is not bent.
|
• |
Release and disconnect 3x wiring harness plug
|
|
|
Install
4. |
Install airbag, driver's side
• |
Connect and latch wiring harness plug
|
|
6. |
Perform readiness check
|
7. |
Program volatile memories
|
|