Vauxhall Workshop Service and Repair Manuals > Corsa D > J Engine and Engine Aggregates | DOHC Petrol Engine | Engine Damping Block | Repair Instructions

Replace engine damping blocks

Note: When removing or replacing the right and left engine damping block or their fixings, the engine must be secured against lowering

The rear engine damping block can also be removed and installed without supporting the engine

1.	Attach engine to corresponding engine transport shackle on engine hoist (1) Note: The diagram shows removal of the right engine damping block

Table for engine damping block fixing

	No.	Designation	Note	Fastening	Tightening Torque
I	1	Rear engine damping block to front axle body		New bolt	80 Nm + 45°
	1	Rear engine damping block to front axle body		New bolt	80 Nm + 45°
	2	Rear engine damping block to engine damping block bracket		New bolt	80 Nm + 45°
	3	Rear engine damping block bracket to transmission		2x new bolts	80 Nm + 45°
II	4	Left engine damping block to side member	Remove battery support. Remove fuse box Hitch engine up to engine crane.	2 bolts	80 Nm
	5	Left engine damping block to left engine damping block bracket		3x new bolts	80 Nm + 45°
	6	Left engine damping block support to transmission	Remove left engine damping block	3x new bolts to transmission	M12: 80 Nm + 30° M10: 60 Nm + 30°
III	7	Right engine damping block to right engine damping block bracket	Remove air cleaner housing Hitch engine up to engine crane.	2x new bolts	80 Nm + 45°
III	7			2x new bolts	80 Nm + 45°
	8	Right engine damping block to right side member	Remove air cleaner housing Hitch engine up to engine crane.	3x bolts	60 Nm
		Right engine damping block bracket to cylinder head and cylinder block	Remove air cleaner housing Hitch engine up to engine crane. Remove engine damping block, right hand side	3x bolts	60 Nm

Vauxhall Workshop Service and Repair Manuals