Replace tie rod (Steering Linkage)

Make

Vauxhall

Model

Corsa D

Section

Steering Linkage › Repair Instructions › Replace tie rod

SteeringReplace tie rod

Replace tie rod 1.   Remove tie rod end 2.   Detach boot 3.   Remove tie rod (1) •   Unscrew using KM-6247 (2) – Slide KM-6247 (2) onto the tie rod to the stop (arrow) •   Counterhold with open-ended wrench (3) against flattening on steering gear 4.   Detach seal ring (2) from steering gear (1) 5.   Attach spacer ring (1) to tie rod. Note:   Attach spacer ring (1) so that the toothing (arrow) makes contact in the direction of the tie rod joint (2).   Install 6.   Attach new seal ring to steering gear 7.   Recut thread on rack •   Apply locking compound 8.   Attach tie rod •   Tighten using KM-6247 to 82.5 Nm •   Counterhold with open-ended wrench against flattening on steering gear 9.   Install tie rod end 10.   Attach bellows

12 Steering & suspension