- Omega B Workshop Manual
- General Vehicle Information
- A Maintenance, Body and Chassis Sheet Metal Parts, Frame
- Repair Instructions
- Description and Operation
- Specifications
- Special Tools and Equipment
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Technical Information
- Sheet Metal Parts (Bolted)
- Sheet Metal Parts (Welded)
- Repair Instructions
- Bodywork repair through structural adhesive
- Instructions - bodywork repair
- Specification for welded, brazed and riveted joints
- Body Repair using Straightening Benches
- Front Panelling Side Bracket, Replace (Partial Replacement)
- Bulkhead, Replace
- Sill - Rear Lower, Replace
- Outer Panelling - Tailgate Door, Replace Replace
- Body Dimension Chart
- Body Repairs with Adhesives and Welding
- Standard Corrosion Protection Measures
- Repl. Clamp Nuts Fastening Front and Rear Axle Comp. And Seat Fastening to Body
- Description and Operation
- Component Locator
- Specifications
- Special Tools and Equipment
- Other Information
- Technical Information
- Body Repair
- A Pillar
- B Pillar
- Members
- Spoiler Assembly
- Wheel Well
- Body Rear End Panel Panel
- Roof Panel
- Floor and Underbody Parts
- Body Side and Quarter Panel
- Trim Panels, Radiator Grille, Spoiler
- Sheet Metal Parts (cement and seal)
- Radiator Grille
- B Paint
- C Body Equipment
- D Heating, Ventilation, Air Conditioning (HVAC)
- E Front Wheel Suspension, Wheels and Tyres
- F Rear Axle and Rear Wheel Suspension
- H Brakes
- J Engine and Engine Aggregates
- K Clutch and Transmission
- L Fuel and Exhaust System
- M Steering
- N Electrical Equipment and Instruments
- R Accessories