Remove
Disconnect ground/earth cable from battery. Raise vehicle.
Remove wiring harness plug (1) from vehicle level control sensor.
Pry out linkage on upper ball head (3). Unscrew fastening screw (2)
on rear axle body and remove vehicle level control sensor and
bracket. If vehicle level control sensor is used: convert bracket
(arrow) from vehicle level control sensor – tightening torque
4 Nm / 3 lbf. ft.
Install
Attach bracket with vehicle level control sensor onto rear axle
body (2) – tightening torque 12 Nm / 9 lbf. ft. Suspend
Linkage on upper ball head. Attach wiring harness plug. Connect
ground/earth cable to battery.
It is not permissible to modify the linkages on the vehicle
level control sensor.
Check function of vehicle level control – see operation
"Automatic Vehicle Level Control, Check".
|