Remove fastening screws (1, 3, 4), remove fastening screw (2)
and swivel retaining strap upwards. Remove power assisted steering
pump from above.
Install
Install power assisted steering pump with fastening screws (3)
and (4) onto auxiliary aggregates holders (3, 4) – tightening
torque 25 Nm / 18.5 lbf. ft.
Fit retaining strap with fastening screw (6) onto power assisted
steering pump and cylinder block – tightening torque 20 Nm /
15 lbf. ft. Connect pressure line (5) to power assisted steering
pump – tightening torque 28 Nm / 21 lbf. ft.
Fit ribbed V-belt and tension – see operation "Ribbed
V-belt, Remove and Install" in group "J". Connect suction line with
new hose clamp (7) to power assisted steering pump.
Charge and bleed hydraulic system – see operation
"Hydraulic System, Charge and Bleed".
|