SteeringRecommended Torque Values (Steering)
|
Recommended Torque Values
Caution
Angle specifications refer to yield
limit controlled fastening bolts, which may only be used once.
Tighten fastening bolts only with the appropriate torque and then
turn further by the specified angle.
| |
Nm
|
|
Exhaust gas recirculation valve and front bracket to auxiliary
aggregates holder
|
20
|
|
Airbag unit to steering wheel
|
8
|
|
Outer tie rods to centre tie rod
|
60
|
|
Electro-hydraulic converter to steering gear
|
2.9
|
|
Retaining bow, fluid reservoir to spring strut dome
|
7
|
|
Retaining strap on power assisted steering pump
|
20
|
|
Retaining shackle to cylinder block
|
20
|
|
Bracket, hydraulic modulator to front frame side member
|
10
|
|
Bracket, idler to front frame side member
|
55 + 75° + 15°
|
|
Brackets, cooling loop to strut
|
4
|
|
Power assisted steering hydraulic lines to power assisted
steering pump
|
28
|
|
Power assisted steering hydraulic lines to power assisted
steering pump (diesel engine)
|
37.5
|
|
Clamp bolt to steering gear
|
22
|
|
Clamp bolt to steering shaft
|
22
|
|
Steering gear to front frame side member
|
55
|
|
Steering wheel to steering shaft
|
20 1)
|
|
Steering arm to steering shaft
|
160
|
|
Steering column with bracket to bulkhead
|
22
|
|
Idler to bracket
|
60
|
|
Centre tie rod to steering arm
|
60
|
|
Centre tie rod to idler
|
60
|
|
Engine damping block
|
40
|
|
Nut, bracket – steering column support
|
22
|
|
Auxiliary aggregates holder to cylinder block
|
40
|
|
Power steering pump to support (X 20 DTH)
|
20
|
|
Power assisted steering pump to auxiliary aggregates holder (4
cylinder engine)
|
25
|
|
Power assisted steering pump to auxiliary aggregates holder (6
cylinder engine)
|
20
|
|
Belt pulley to power assisted steering pump
|
20
|
|
Return line to engine transport shackle
|
4
|
|
Tie rod end to steering knuckle
|
60
|
|
Tie rod end to centre tie rod
|
60
|
|
Steering column support to bracket
|
22
|
|
Sleeve nut, power assisted steering hydraulic lines to screwed
socket
|
18
|
|
Sleeve nut, power assisted steering hydraulic lines to steering
gear
|
28
|
|
Front exhaust pipe
|
20
|
|
Heat shield to upper steering gear
|
8
|
|
Heat shield to lower steering gear
|
15
|
|
Hydraulic unit heat shield to holder
|
8
|
1 ) Tighten fastening nut to 20 Nm/15 lbf. ft.,
then release by 90° and re-tighten to 20 Nm/15 lbf. ft.
|
|
| Related Literature Units |
|---|
| - | | | - | |
|
12 Steering & suspension
