Floor - Rear, Replace (Models F35, F19, F68) (Additional operation to the operations "Rear Quarter Panel, Replace", "Lower Rear End Panel, Replace Completely", Inner Rear Quarter Panel, Replace" and "Rear End Panel Crossmember, Replace".)
 Remove, Disconnect Attaching parts. Detach rear floor panel according to size of new part.
 Install, Connect Fit rear floor panel. Prepare flanges. Apply spot weld paint. Weld in new part. Seal cavities. Apply underseal. Attaching parts.
|
Separation line 1 = |
Models F19, F68 |
|
Separation line 2 = |
Model F35 |
| 
|
Notice: As of Model Year 2001, the pin fastening for the heat shield in the area of the rear body floor has been changed by adding 2 screw pins. Once they have all been used, the Aftersales division will supply body sheet metal parts as of Model Year 2001. When replacing the rear floor or rear floor heat shield, if the fastening holes in the heat shield do not coincide with the position of the welding pins, proceed as follows.
Install, Connect Hold heat shield against the vehicle floor and transfer fastening points. Drill 8 mm bore at marked positions on the heat shield. Attach heat shield.
|
