Wheel Brake Cylinder, Remove and Install
 Remove, Disconnect Correct brake fluid level up to "MAX" marking and seal with Dummy Screw Cap MKM-558-10. Detach rear wheel. Remove brake shoes - see operation "Brake Shoes, Drum Brake, Remove and Install". Unscrew brake line (2) - collect escaping brake fluid seal fluid apertures. Unscrew bolt (1) and remove wheel brake cylinder.
 Inspect Check brake shoes - brake shoes which are soiled with brake fluid must be replaced. | 
|
 Install, Connect Attach wheel brake cylinder to brake anchor plate. Attach brake line to wheel brake cylinder. Install brake shoes - see operation "Brake Shoes, Drum Brake, Remove and Install".
Inspect Remove dummy screw cap from brake fluid reservoir. Bleed brake system bleed and check for leaks - see operation "Brake System, Bleed and Check for Leaks".
 Tighten (Torque) Wheel brake cylinder to brake anchor plate - 9 Nm / 7 lbf. ft. Brake line to wheel brake cylinder - 16 Nm / 12 lbf. ft. Wheel to wheel hub - 110 Nm / 81 lbf. ft.
|
