Checking and Adjustment Values (X 25 XE, Y 26 SE)
Engine |
|
X 25 XE |
Idle speed |
|
|
|
with manual transmission with automatic transmission |
rpm rpm |
570 - 730 1) 570 - 730 1) |
Maximum rpm |
rpm |
6800 1) |
CO content |
Vol. % |
1) |
Spark plug electrode gap |
mm |
0.9 - 1.1 |
Compression pressure |
kPa |
1200 - 1500 2) |
Pressure loss |
|
not more than 25% per cylinder |
Valve clearance |
mm |
0 |
Ignition timing at idle speed |
|
1) |
1) Correction and adjustment according to Checking Procedure with TECH 2. 2) The pressure difference between individual cylinders should not exceed 100 kPa (1 bar).
When checking the idle speed and the CO content, ensure the following: |
- Electrical consumers switched off
- Engine at operating temperature (oil temperature ≥ 80 ° C / 176 ° F).
- Selector lever in position "P" with automatic transmission
- CO test with 2,800 to 3,200 rpm without load
Checking and Adjustment Values (Continued)
Engine |
|
X 25 XE (as of MY '99) |
Y 26 SE |
Idle speed |
|
|
|
|
with manual transmission with automatic transmission |
rpm rpm |
640 - 800 1) 640 - 800 1) |
580 - 800 1) 580 - 800 1) |
Maximum rpm |
rpm |
6700 1) |
6800 1) |
CO content |
Vol. % |
1) |
1) |
Spark plug electrode gap |
mm |
0.9 - 1.1 |
1.25 - 1.45 |
Compression pressure |
kPa |
1200 - 1500 2) |
1200 - 1500 2) |
Pressure loss |
|
not more than 25% per cylinder |
not more than 25% per cylinder |
Valve clearance |
mm |
0 |
0 |
Ignition timing at idle speed |
|
1) |
1) |
1) Correction and adjustment according to Checking Procedure with TECH 2. 2) The pressure difference between individual cylinders should not exceed 100 kPa (1 bar).
When checking the idle speed and the CO content, ensure the following: |
- Electrical consumers switched off
- Engine at operating temperature (oil temperature ≥ 80 ° C / 176 ° F).
- Selector lever in position "P" with automatic transmission
- CO test with 2,800 to 3,200 rpm without load
|