Install, Connect
Attach rear toothed belt cover to oil pump and cylinder head - tightening torque 8 Nm / 5.9 lbf. ft.
Attach toothed belt drive gear to crankshaft with new fastening bolt - counterhold using KM-662-C - tightening torque 130 Nm / 96 lbf. ft. + 40 ° to 50 ° .
Attach return roller bracket to cylinder block - tightening torque 25 Nm / 18.4 lbf. ft.
Connect toothed belt return roller to cylinder block - tightening torque 25 Nm / 18.4 lbf. ft.
Connect toothed belt return roller to return roller bracket - tightening torque 25 Nm / 18.4 lbf. ft.
Attach toothed belt tension roller to oil pump - tightening torque 20 Nm / 15 lbf. ft.
Connect adapter to cylinder head - tightening torque 60 Nm / 44.2 lbf. ft.
Attach camshaft sensor to cylinder head - tightening torque 6 Nm / 4 lbf. ft.
Install camshaft sprockets - see operation "Camshaft Sprockets, Remove and Install".