Transmission Output and/or Input Speed Sensor, Remove and Install
Remove, Disconnect Remove battery - to do this, remove small relay box from bracket. If required, remove coolant compensation tank - to do this, remove clamp (3) and hose (4) - set aside tank. Remove sensor for transmission input speed (1), sensor for transmission output speed (2) - to do this, disconnect relevant wiring harness plug. Replace seal ring. |
|
Install, Connect Attach relevant sensor to transmission. Secure coolant compensation tank, fit hose. Top up and bleed cooling system - see operations "Cooling System, Top Up and Bleed" and "Cooling System, Check for Leaks" in group "J".
Tighten (Torque) Sensors to transmission - 6 Nm / 4 lbf. ft. |
|
|