Bearings for Intermediate Shaft in Clutch Housing, Remove and Install (F 23) Illustration
|
Intermediate shaft bearing (1) |
|
Retaining ring (2) |
 Remove, Disconnect Remove transmission - see operation "Transmission, Remove and Install (F 23)".
 Disassemble Disassemble transmission - see operation "Transmission, Seal Completely (F 23)". | 
|
Remove, Disconnect Remove retaining ring (2) with retaining ring pliers (1). Drive intermediate shaft bearing out of clutch housing (4) with KM-248 (3).
 Inspect Clean all removed parts and check for wear and damage, replace if necessary. | 
|
Remove, Disconnect Drive intermediate shaft bearing into clutch housing (5) with KM-6119 (4) in conjunction with KM-523-1 (3). Install new retaining ring (2) with retaining ring pliers (1). Notice: Ensure correct seating of retaining ring in clutch housing. | 
|
 Assemble Assemble transmission - see operation "Transmission, Seal Completely (F 23)".
 Install, Connect Install transmission - see operation "Transmission, Remove and Install (F 23)".
|
