Axle Shaft Seal Ring and O-Ring in Left Gasket Flange - Transmission Casing, Replace (F 25)
Remove, Disconnect Remove seal flange (1) (5 bolts). Remove spacer washer. Press out the axle shaft seal ring with KM-523-1 (4) and KM-523-3 (2) - counterhold with KM-500-2 (3). |
|
Remove, Disconnect Remove O-ring from sealing flange with small screwdriver.
Install, Connect Press in axle shaft seal ring with KM-519 (1). Coat axle shaft seal ring with transmission fluid. Coat new O-ring with transmission fluid and attach to sealing flange.
Tighten (Torque) Mount sealing flange and spacers (5 fastening bolts) - 22 Nm / 16 lbf. ft. |
|
|