Outside Rear View Mirror Outside Rear View Mirror, Remove and Install
 Remove, Disconnect Remove front door assist handle - see operation "Assist Handle - Front Door, Remove and Install" in group "C". Remove mirror corner. Unscrew rear view mirror (3 screws), detach rear view mirror partially, and release and disconnect wiring harness plug.
 Install, Connect Connect wiring harness plug and screw rear view mirror onto door.
 Adjust Bonnet / rear view mirror casing joint. Turn eccentric bolt (1) until rear view mirror casing adjoins the rubber seal for the bonnet. | 
|
Adjust Deviation in length - bonnet / rear view mirror casing (Fig. I). Dim. A: 4 + 1 mm Lateral deviation - bonnet / rear view mirror casing (Fig. II). Dim. B: 0 ± 1.5 mm Vertical deviation - bonnet / rear view mirror casing (Fig. III). Dim. C: 0 ± 2 mm | 
|
Notice: For deviations: Correct adjustment using fastening screws (3 screws). If there are larger deviations, carry out the adjustment on the bonnet - see operation "Bonnet, Bonnet Functioning Parts, Remove and Install (Models F35, F19, F68)" in group "A".
Install, Connect Attach mirror corner. Attach front door assist handle - see operation "Assist Handle - Front Door, Remove and Install" in group "C". |
|
|
