Beetle L4-1.9L DSL Turbo (ALH) (1998)
Rapid data transfer
->
No signal from control module
-
Check wiring connections for Data Link Connector (DLC), as well as voltage supply and Ground (GND) connections.
Rapid data transfer
->
Error in communication link
-
After repairs press buttons -4- and -6- to input "Comfort System" address word 46.
Indicated on display
Rapid data transfer
Scan Tool sends address word 46
The central control module identification for comfort system -J393- (Conv. cent. 07) is indicated on the VAG 1551 scan tool display.
1J0 959 799 AJ 5X Conv. cent. CU 0001 ->
Coding XXXXX
WSC XXXXX
-
Press -> button.
After displaying all other control modules:
Indicated on display
Rapid data transfer
HELP
Select function XX
NOTE:
-
A list of possible functions is printed out after pressing the "HELP" button.
-
Do not select further functions, which can be printed out after pressing the "HELP" button.
-
After the function is completed the VAG 1551 returns to the start position.
Rapid data transfer
HELP
Select function XX
With Manufacturer Scan Tool
Check DTC Memory (Function 02)
NOTE: The VAG 1552 Mobile Scan Tool (ST) can be used instead of the VAG 1551 Scan Tool (ST), however a print-out is not possible.
-
Connect VAG 1551 scan tool. Refer to "Selectable Functions When Using VAG 1551", under "Restraint Systems", See: Scan Tool Testing and
Procedures/Scan Tool Connecting and Initial Checks
-
Initiate On Board Diagnostic (OBD). See: Initial Inspection and Diagnostic Overview/On Board Diagnostic (OBD), Initiating Program
-
Switch printer on with "PRINT" button (warning lamp in button lights up).
-
Press buttons -0- and -2- to select "Check DTC Memory" function 02.
Indicated on display
Rapid data transfer
Q
02 - Check DTC Memory
-
Press "PRINT" button.
-
Press -Q- button to confirm input.
Indicated on display (number of stored DTCs)
X DTC recognized
->
The stored DTCs are displayed and printed out one after the other.
Indicated on display