Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Initiate On Board Diagnostic (OBD). See: Initial Inspection and Diagnostic Overview/On Board Diagnostic (OBD), Initiating Program
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -7- to select "Code Control Module" function 07.
Indicated on display
Rapid data transfer
Q
07 - Code Control Module
-
Press -Q- button to confirm input.
Indicated on display
Code Control Module
Q
Enter code number XXXXX (0-32000)
-
Enter code number 00256.
-
Press -Q- button to confirm input.
The control module identification number will be displayed with the appropriate index letter index, the code number and the dealership number.
1J0 959 799 AJ 5X Conv. cent. CU 0001 ->
Coding XXXXX
WSC XXXXX
If the contents of the display are as shown the coding is successful.
If the code number entered is not accepted by the control module, the previous coding will appear in the display.
Indicated on display
Mistake
0062 ->
Code not accepted
WSC XXXXX
In this case the control module has not been programmed with the relevant data for the vehicle. A test must be completed to determine if the correct
control module for the vehicle has been installed (compare Part No. and letter index), or whether an incorrect code number has been entered.
-
Repeat coding.
The following code numbers (and others) will be accepted by the control module; however they are for other vehicles, other countries and/or other
equipment levels.
Coding table