Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Reinstall (3) torx screw -2- and washer and torque to 1.3 to 1.5 Nm (11 to 13 in.lbs)
STEERING WHEEL NOT SHOWN FOR CLARIFICATION PURPOSE.
-
Carefully remove the (2) clips -5- from the tabs on the back edge of the center instrument panel trim
Install (2) new dips -6-, ICO 858 264, on the tabs of the center instrument panel trim then install (2) new clips -7-, 1J0 858 137 A, over clips -6-
-
Reinstall center plenum panel cover -1- by sliding rearward until clips snap into position.
-
Remove flower vase -8- by turning it counterclockwise, then lifting upward
-
Remove mounting base -9- by pulling it rearward
-
Install new mounting base -9-, 1C1 858 014A 2AQ, by inserting clips in slotted holes of dash and pressing forward and to the right until the clips
are seated
-
Reinstall flower vase -8- by inserting it into the mounting base and turning it clockwise.
-
Properly dispose of all the replaced parts.
IMPORTANT: The BV code is displayed in the V_Crest inquiry system; it is necessary to check for this "open" code prior to performing the work.