Beetle L4-1.9L DSL Turbo (ALH) (1998)
Compressor Clutch: Service and Repair
A/C Clutch -N25-, Removing and Installing
Special tools, testers, measuring instruments and auxiliary items required
-
Tool 3212 A (or equivalent)
-
Two arm puller
-
Three arm puller
-
Depth gauge
-
Torque wrench (5 - 50 Nm)
NOTE:
-
It is not necessary to discharge the refrigerant system to remove and install the A/C clutch.
-
If A/C clutch is to be removed with compressor installed, first do the following:
-
Remove ribbed belt.
-
Remove intercooler (engine code ALH only).
-
If A/C clutch is to be removed with compressor removed, first discharge refrigerant system. Refer to "A/C Refrigerant System, Discharging" See:
Service and Repair
Hex nut, removing and installing
-
Tightening torque: 15 Nm (11 ft. lb)
-
Remove hex nut while counter-holding with 3213A or equivalent commercially available 2 hole pin wrench (with 4 mm pins).
Clutch plate, removing