Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-1054002.png)
^
Remove left noise insulation panel -arrows-.
^
Remove bolts of drive shaft from drive flange.
^
Remove pendulum support from sub-frame -arrows-.
^
Mark installation position of ball joint bolts on left control arm and remove bolts.
^
Remove bolts -arrows-.
^
Detach left coupling rod -1- from control arm and turn coupling rod upward.
^
Swing wheel bearing housing outward.
^
Guide drive shaft out between sub-frame and transmission while pushing engine and transmission assembly forward (you need a second
technician).
^
Lift drive shaft and secure to suspension strut with wire.
Continued for both oil seals:
^
Pierce sealing cap in drive flange with screwdriver and pry out.
