Beetle L4-1.9L DSL Turbo (ALH) (1998)
^
Remove spindle from bridge -A- of puller Kukko 18-0.
^
Instead install spindle with nut of assembly tool 3301.
^
Bolt puller Kukko 18-0 to flange using two 8x35 mm bolts and 8 mm washers.
^
Remove circlip -arrow- for axle flange.
^
Remove spindle with nut from assembly tool 3301.
^
Pre-install spindle -B- of puller Kukko 18-0 again in bridge -A-.
^
Place drip tray underneath.
^
Remove axle flange.
^
Pull out drive flange oil seal with VW 681.
^
Install new oil seal to stop with press piece 3319, M10 threaded rod approx. 80 mm (3 inch) long and nut with washer.
^
Fill space between sealing lip and dust lip with multi-purpose grease.
^
Install drive flange, dished washer and circlip.
^
Remove spindle of puller Kukko 18-0 from bridge -A-
^
Instead install spindle and nut of assembly tool 3301.
^
Insert drive flange, dished washer and circlip.
^
Bolt puller Kukko 18-0 using two 8x35 mm bolts and 8 mm washers to flange.
^
Pull in drive flange.
Note:
Drive flange can also be pulled in with VIN 391.