Beetle L4-1.9L DSL Turbo (ALH) (1998)
^
Install circlip and seal drive flange with cover.
^
Reconnect ball joint to control arm.
^
Tighten bolts -arrows- to tightening torque.
^
Attach coupling rod to control arm.
^
Install drive shaft.
^
Install road wheel.
^
With transmission installed, check final drive oil level.
^
Install noise insulation panel.
Tightening torques
Drive shaft to drive flange 40 Nm (30 ft. lbs.)
Ball joint to control arm 20 Nm (15 ft. lbs.) + 90°
Coupling rod to control arm 46 Nm (33 ft. lbs.)
Pendulum support to sub-frame 20 Nm (15 ft. lbs.) + 90°
Wheel bolts to wheel hub 120 Nm (89 ft. lbs.)
Protective cap/drive shaft to engine 33 Nm (24 ft. lbs.)