Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Hold wheel bearing housing tightly and remove bolts - arrows -.
-
Pull connecting link - 1 - out from trailing arm.
Installing
Only tighten bolts for longitudinal control arm/wheel bearing housing if all other components (especially spring and shock absorber) of appropriate
suspension are already installed. To tighten, suspension must be unladen. Only then will longitudinal control arm and wheel bearing housing move to
required position - arrows -.
The sequence of the following work steps must absolutely be observed!
-
Install bolt for tie rod - 1 -, upper transverse link - 2 - and lower transverse link - 3 - but do not tighten yet.
-
Install coupling rod - arrow - on wheel bearing housing hand-tight.
-
Install bolts - arrows - and insert connecting link - 1 - into trailing arm.