Eos (1F7) V6-3.2L (BUB) (2008)
‹› With wear indicator.
‹› When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in instrument cluster.
‹› Wear limit: 2 mm without backing plate.
‹› Must always be replaced together on both sides of axle.
‹› Removing and installing, refer to => [ Brake Pads ] See: Disc Brake System/Brake Pad/Service and Repair.
5
Retaining spring
‹› Insert in both holes of brake caliper.
6
Brake carrier
‹› Bolt to wheel bearing housing.
7
Brake caliper
‹› Do not remove brake hose when replacing brake pad.
‹› Removing and installing, refer to => [ Brake Caliper ] See: Brake Caliper.
‹› Disassembly, refer to => [ Brake Caliper Assembly Overview ] See: Brake Caliper Assembly Overview.
8
Guide pins, 30 Nm
9
Cap
‹› Remove
10
Brake hose with banjo fitting and union bolt, 35 Nm
11
Guide pins, 30 Nm
12
Cap
‹› Remove
13
Bolt
14
Bracket
15
Ribbed bolt, 190 Nm
‹› Clean if reusing.
16
Wheel bearing housing
‹› With bolted brake carrier.
17
Wheel speed sensor
‹› Before inserting sensor, clean inner surface of bore hole and coat with hot bolt paste (G 052 112 A3).
18
Bolt, 8 Nm
19
Wheel bearing/hub unit
‹› The Anti-lock Brake System (ABS) sensor ring is installed in the wheel bearing.
20
Cover plate
FNR-G