Eos (1F7) V6-3.2L (BUB) (2008)
‹› The milled tooth aligns with the crankshaft bearing cap joint = cylinder 1 Top Dead Center (TDC). Refer to => [ Intermediate Shaft and
Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
15
Timing Chain
‹› Mark the direction of rotation before removing (installed position).
‹› Installing, refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
16
Guide Rail
‹› Remove and install together with the timing chain. Refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and
Timing Chains, Installing.
17
Locating Pin without Collar
‹› 10 Nm
‹› For the guide rail - item 16 -.
18
Pivot Pin
‹› 18 Nm
19
Bolt
‹› 23 Nm
20
Intake Camshaft Adjuster
‹› Identification: 24E
‹› Only rotate the engine with the camshaft adjuster installed.
‹› Installing, refer to => [ Intermediate Shaft and Timing Chains, Installing ] See: Intermediate Shaft and Timing Chains, Installing.
21
Bolt
‹› 60 Nm + 90° (1/4) additional turn
‹› Replace
‹› Bolt head contact surface of the adjuster must be dry when installing.
‹› To remove and install, counter hold at the camshaft using a 32 mm open end wrench. Refer to => [ Camshafts ] See: Camshaft, Lifters and
Push Rods/Camshaft/Service and Repair.
22
Guide Rail
‹› For the camshaft timing chain - item 3 -.
23
Camshaft Adjustment Valve 1 (Exhaust) (N318)
‹› For the exhaust camshaft
‹› Removing and installing, refer to => [ Camshaft Adjuster Valves ] See: Variable Valve Timing/Variable Valve Timing Actuator/Service and
Repair/Camshaft Adjuster Valves.
‹› Mark the connector belonging to the component before disconnecting.
24
Camshaft Adjustment Valve 1 (N205)
‹› For the intake camshaft.
‹› Removing and installing, refer to => [ Camshaft Adjuster Valves ] See: Variable Valve Timing/Variable Valve Timing Actuator/Service and