Eos (1F7) V6-3.2L (BUB) (2008)
-
Disconnect electrical connections from heating and A/C unit.
NOTE: All cable ties opened or cut during removal must be reinstalled at the same locations during installation.
-
Remove bolts from bracket.
-
Remove supports and.
-
Remove bolts and and remove bracket.
-
Remove bolts and from cable bracket.
- When removing heating and ventilation unit, make sure the two coolant pipes of the heater core do not get caught and bent or damaged
on plenum chamber or sound insulation pan.
- Also pay attention to wiring harness, individual wiring connections may get damaged when pulling too forcefully on wiring harness.
-
Remove heating and ventilation unit.
Installing:
Install in reverse order, noting the following:
NOTE: The assistance of a second mechanic is necessary to install the heating and ventilation unit.
-
When inserting heating and ventilation unit, have the second mechanic guide both coolant pipes to heater core through the seal (from engine
compartment)
-
Fill with coolant.
5
-
Bracket
6
-
Assembly carrier
7
-
Bolts
-
9 plus/minus 1.3 Nm
8
-
Right support
9
-
Left support
10
-
Bolts
-
Qty. 2
-
9 plus/minus 1.3 Nm
11
-
Bracket
12
-
Bolts
-
Qty. 2
-
9 plus/minus 1.3 Nm
Seal for heating and A/C unit / engine compartment
NOTE: Note installation position of seal - A - during assembly.