Eos (1F7) V6-3.2L (BUB) (2008)
-
Pull control arm out of lower ball joint.
-
Pull the drive axle out of the wheel hub.
-
Remove bolts - arrows -.
-
Remove wheel bearing unit from wheel bearing housing.
Installing
Installation is performed in the reverse order of removal.
-
Install brake caliper.
-
Tighten drive axle bolt to wheel hub:
‹› Hex head bolt, refer to => [ Drive Axle Hex Bolt Connection, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Removal
and Replacement.
‹› Twelve point bolt, refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and
Repair/Procedures.
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
-
Install ABS wheel speed sensor.
-
Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Wheel Fastener/Specifications.
Tightening Specifications