Volkswagen Workshop Service and Repair Manuals

Note:

Locking cable must only be adjusted in its installation position .

• ‒ Shift selector lever into "1" position.
• ‒ Turn ignition key to right (starting position) and release.
• ‒ → Adjust clearance to 0.7 mm between lever -1- and locking pin -2- by sliding locking cable casing.

Dimension a = 0.7 mm

• ‒ Tighten locking cable anchorage screw in this position to 6 Nm.
• ‒ Shift selector lever into "P" position and turn ignition key to end position.
• ‒ Pull out ignition key.

• ● It must only be possible to remove ignition key in this selector lever position.
• ● Selector lever cannot be shifted out of "P" position.