Volkswagen Workshop Service and Repair Manuals > Golf Mk3 > Power transmission | Automatic gearbox 096 | Self diagnosis, V.A.G Inspection Service | Gearbox: Electrical check | Electrical check of 68-pin connectors | Multi-pin connection (68-pin connector) of automatic gearbox control unit J217 (sockets on test box V.A.G 1598/18 )

Multi-pin connection (68-pin connector) of automatic gearbox control unitJ217 (sockets on test boxV.A.G 1598/18)

Multi-pin connection (68-pin connector) of automatic gearbox control unit -J217- (sockets on test box -V.A.G 1598/18-)

1-	Earth (terminal 31)	35-	Vacant
2-	Vacant	36-	L-wire for diagnosis
3-	Vacant	37-	Vacant
4-	Vacant	38-	Vacant
5-	Throttle valve potentiometer -G69- signal → Note	39-	Vacant (for VW)
6-	Gearbox oil temperature sender -G93- (ATF)	40-	Multifunction switch -F125-
7-	Vacant	41-	Load signal from engine control unit
8-	Vacant	42-	Engine speed sender (screening) for diesel
9-	Solenoid valve 3 -N90-	43-	Vehicle speed sender -G68- (screening)
10-	Solenoid valve 7 -N94-	44-	Vacant
11-	Park/neutral signal	45-	Vacant
12-	Kickdown for air conditioner	46-	Vacant
13-	Ignition timing control	47-	Solenoid valve 4 -N91-
14-	Vacant	48-	Vacant
15-	Brake light switch -F- signal voltage	49-	Vacant
16-	Kickdown switch -F8-	50-	Throttle valve potentiometer -G69- (5 Volt) → Note
17-	Vacant	51-	Vacant
18-	Multifunction switch -F125-	52-	Vacant
19-	TDC signal (rpm)	53-	Vacant
20-	Vehicle speed sender -G68-	54-	Solenoid valve 2 -N89-
21-	Vacant	55-	Solenoid valve 1 -N88-
22-	Voltage supply for solenoid valve 6 -N93-	56-	Solenoid valve 5 -N92-
23-	Supply voltage (terminal 15)	57-	Selector lever display
24-	K-wire for diagnosis	58-	Solenoid valve 6 -N93-
25-	Vacant	59-	Vacant
26-	Vacant	60-	Cruise control system (input, terminal 15)
27-	Vacant	61-	Cruise control system (output)
28-	Throttle valve potentiometer -G69- earth → Note	62-	Multifunction switch -F125-
29-	Selector lever lock solenoid -N110-	63-	Multifunction switch -F125-
30-	Vacant	64-	Engine speed sender -G28-
31-	Vacant	65-	Vehicle speed sender -G68- (diesel engine)
32-	Vacant	66-	Vacant
33-	Vacant	67-	Voltage supply for solenoid valves
34-	Vacant	68-	Vacant

¹⁾	Voltage supply and signal (contacts 50, 28 and 5) vacant on vehicles with a 6-cylinder engine or Simos engine, signal (contact 41) is transmitted to gearbox control unit via engine control unit and can only be checked in measured value block → Chapter.