Servicing valve gear
Checking hydraulic bucket tappets
Notes:
-
◆ Renew defective tappet complete (cannot be adjusted or repaired).
-
◆ Irregular valve noises when starting engine are normal.
-
‒ Start engine and run until the radiator fan has switched on once.
-
‒ Increase engine speed to about 2500 rpm for 2 minutes.
If the hydraulic tappets are still noisy, locate defective tappets as follows:
-
‒ Remove cylinder head cover =>Page 15-9
.
-
‒ Rotate crankshaft clockwise on vibration damper securing bolt, until cam of the tappet to be checked is pointing upwards.
-
‒ Determine play between cam and bucket tappet.
-
‒ If the play is in excess of 0.1 mm, renew bucket tappet. If the play is less than 0.1 mm or no play, proceed with check as follows:
|