volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing CCS vacuum pump (V18) > < Removing and installing vent valve

Golf Mk3

Electrical system
Mechanical cruise control system (CCS) in petrol and diesel engine vehicles (not TDI and SDI)
Removing and installing CCS control unit (J213)

Removing:

  • ‒ Remove drivers' side dash panel trim
  • ‒ Pull 12 pin connector off cruise control system control unit (J 213), located behind assembly carrier on left A-pillar

Only for vehicles with anti-theft warning system:

  • ‒ Pull 6 pin and 10 pin connector off anti-theft system control unit (J 284), located behind assembly carrier on left A-pillar
 
N96-0011

Note:

For vehicles with anti-theft warning system, the anti-theft warning system control unit (J 284) and cruise control system control unit (J213) are located on the same securing plate.

  • ‒ → Remove hexagon nut -1- from assembly carrier, near left A-pillar
  •      2 -     Cruise control system control unit (J 213)
  • ‒ Pull securing plate locking lugs out from assembly carrier and pull securing plate with control unit out from behind assembly carrier
  • ‒ Remove control unit securing bolts from securing plate

Removing and installing CCS vacuum pump (V18) > < Removing and installing vent valve