Volkswagen Golf Workshop Service and Repair Manuals

Note:

Multi-pin connector pin assignment

=> Current flow diagrams, Electrical fault finding and Fitting locations.

Removing multi-pin plug

• ‒ → Pull the retaining slide -1- on rear of relay plate out of the housing -arrow- as far as possible (about 5 mm).

• ‒ → Press retaining lug on multi-pin connector -arrow- and pull out of relay plate.

→ Installing multi-pin connector

Note:

Insert connector so that the locking pin -2- face towards locking slide -1-.

• ‒ Push multi-pin connector into appropriate location as far as stop with locking pin -2- located in recess -4- until retaining tab -3- engages.
• ‒ Push locking slide -1- against stop -arrow-; only possible when all multi-pin connectors are pushed in until the retaining tabs -3- are engaged.