Workshop Manuals Factory service & repair Volkswagen
01 Running gear02 Body03 Engine04 Vehicle electrics05 Power transmission06 Heating, ventilation, air conditioning07 Power unit08 Heating, ventilation, air conditioning system
Volkswagen Golf Mk404 · Vehicle electrics
04 · General

Connecting battery

Make
Volkswagen
Model
Golf Mk4
Section
Starter-current supply-CC › Disconnecting and reconnecting batteries › Connecting battery
Vehicle electricsConnecting battery
Connecting battery
Connecting battery – Volkswagen Golf Mk4   Caution
Observe notes for battery terminal connection → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
Connecting battery – Volkswagen Golf Mk4  Note
  W00-0427
The illustration shows the battery of a vehicle with clipped-on fuse holder -3-. The batteries of vehicles with bolted-on fuse holder are connected in the same way.
  N27-0263
–  Attach positive terminal clamp -1- to battery positive terminal.
–  Tighten securing bolt of positive terminal clamp to specified torque setting → Chapter.
  N27-0263
–  Only after positive terminal clamp is secure may negative terminal clamp -2- be attached to battery negative terminal.
–  Tighten securing bolts of battery terminal clamps to specified torque setting → Chapter.
–  Close heat shield jacket, if fitted.
–  Carry out the procedures as detailed in the table.
Procedure after reconnecting battery
  N27-0263
ProcedureCompleted
Switch ignition on and off again using ignition key 
Read fault memory: → Guided fault finding using VAS 5051A. 
Clock: check time/settings and adjust if necessary 
Electric window regulators: open all windows fully and close again, move switch to “Close” position again and hold at this position until control unit switches 
Check function of all electrical consumers 

If necessary, table can be printed out.
   

Parts & tools for this job For Volkswagen Golf

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.