Golf Mk5
| Assembly overview - removing and installing gearbox housing and selector mechanism |
| 1 - | Countersunk bolt, 25 Nm |
| 2 - | Flange shaft with compression spring |
| q | Removing and installing → Chapter |
| q | Assembling → Chapter |
| 3 - | Torx socket head bolt, 25 Nm |
| q | For reverse shaft support |
| q | Self-locking |
| q | Always renew |
| 4 - | Torx socket head bolt, 30 Nm |
| q | For reverse shaft support |
| q | Self-locking |
| q | Always renew |
| 5 - | O-ring |
| q | Always renew |
| 6 - | Pivot pin |
| 7 - | Bolt, 25 Nm |
| 8 - | Bolt, 25 Nm |
| 9 - | Cover plate |
| 10 - | Multi-point socket head bolt 25 Nm |
| q | For reverse shaft support |
| q | Always renew |
| 11 - | Bolt, 5 Nm |
| 12 - | Gearbox neutral position sender -G701- |
| q | for vehicles with start/stop system |
| 13 - | Gearbox housing |
| q | Pull off together with 5th and 6th gears → Chapter. |
| q | Repairing → Chapter. |
| 14 - | Clutch housing |
| q | Repairing → Chapter. |
| 15 - | Hexagon bolt, 25 Nm and turn 90° further |
| q | Always renew |
| 16 - | Selector shaft with selector shaft cover |
| (Selector unit) |
| q | Repairing → Chapter. |
| 17 - | Multi-point socket head bolt 25 Nm |
