Golf Mk5
Assembly overview - electromechanical steering box, right-hand drive vehicle (2nd generation) up to model year 2008 |
Note
t | There are no 2nd generation steering boxes available as spare parts. |
t | If the steering box has to be replaced, a new 3rd generation steering box will have to be fitted. |
t | In addition, the electrical wiring harness from the E-box to the steering box will then also have to be renewed. This is included with the order for the new steering box via the → Electronic parts catalogue„ETKA“. |
t | The electrical wiring harness will be delivered with the cable for the service interval display. |
t | In vehicles without a service interval display, the unused 3-pin connector must be sealed by a flat contact housing with connector position assurance -1J0 973 803- → Electronic parts catalogue„ETKA“. |
1 - | Universal joint |
2 - | Bolt |
q | M8 x 35 |
q | 30 Nm |
q | Always renew after removing. |
3 - | Wiring |
4 - | Shield |
5 - | Torx bolt |
q | 6 Nm |
q | Self-locking |
6 - | Clamp |
q | Always renew after removing. |
7 - | Rubber mounting |
8 - | Power steering box |
q | With power steering control unit -J500- |
q | With electromechanical power steering motor -V187- |
q | With steering torque sender -G269- |
q | Can be checked in guided fault finding of the vehicle diagnostic, testing and information system -VAS 5051B-. |
q | Removing and installing → Chapter. |
q | Observe notes → Anchor. |
9 - | Connecting piece |
10 - | Wheel bearing housing |
11 - | Nut |
q | M12 x 1.5 |
q | 50 Nm |
q | Self-locking |
q | Always renew after removing. |
12 - | Subframe |
13 - | Bolt |
q | M10 x 70 |
q | 50 Nm + 90° further |
q | Always renew after removing. |