volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing lid lock > < Adjusting striker pin

Golf Mk6

Adjusting adjustment buffer
Adjusting adjustment buffer
  Note
t  Only the adjustment for the right adjustment buffer is described. The adjustment for the left adjustment buffer is similar.
t  To remove and install turn complete adjustment buffer -1- through 90°.
   
–  Loosen clamping bolt -4- until it is visible in rubber buffer.
–  Pull detent slide -3- out of adjusting buffer -1-.

   
–  Adjust detent slide to dimension -a- = 12.5 mm.
–  Close rear lid in preliminary detent position with slight pressure in the middle.
  N55-0159
–  Open rear lid again.
–  Set adjustment buffer clamping screw -1- to a depth of -a - = 20 mm.
–  Check the adjustment.
  N55-0212

Removing and installing lid lock > < Adjusting striker pin